Sean Williams - ITPro68

Recently, a Windows 10 computer I was working on would not allow me to change any network setting from the GUI.  I needed to change to a static IP address from DHCP to do some maintenance.  I also needed to add a secondary IP address.  How did I do this?  The step are below and may come in handy to someone else.

Set IP Address to Static from Powershell

1. Disable DHCP
   Open PowerShell
   Get-NetAdapter

   
   (note) review the output from the above command to get the Interface Name
   Get-NetAdapter –Name Ethernet
   Set-NetIPInterface -DHCP Disable

2. Set IP Address

   New-NetIPAddress -AddressFamily IPv4 –InterfaceAlias “Ethernet” -IPAddress 192.168.1.100 -PrefixLength 24 -Type Unicast -DefaultGateway 192.168.1.1

   (note) -IPAddress 192.168.1.100 change to the IP Address you want to assign

   (note) –PrefixLength is the Mask -24 is 255.255.255.0

   (note) –DefaultGateway 192.168.1.1 change to the gateway for your network
   Set Static DNS Servers

   Primary:               netsh interface ip add dns name="Ethernet" addr=192.168.1.10 index=1
   Secondary:         netsh interface ip add dns name="Ethernet" addr=192.168.1.11 index=2
   Tertiary:               netsh interface ip add dns name="Ethernet" addr=8.8.8.8 index=3

3. Add Secondary IP Address (If you want to add another IP Address to your interface)
   netsh interface ipv4 add address name=Ethernet 192.168.2.100 mask=255.255.255.0

Set DHCP from Powershell

1. Enable DHCP

   Get-NetAdapter -Name Ethernet
   Set-NetIPInterface -DHCP Enable
   netsh interface ip set dns name="Ethernet" dhcp